[Daryl]

I'm far from the expert on the "Endless Belt Effect" because all that I can understand from it is that although the Clubhead Surface Speed increases when going from a straight line to around the pulley, the RPM of the Hands and Clubhead should remain the same.

This is possible only if and for as long as, Inertia can hold the Clubhead inside the arc of the Hands or hold to a Line Delivery Path (2-L). Centrifugal Force will set in when the Clubhead crosses to the out-side and it will begin to pull into its own incidental orbit per 2-P and 2-K#5.

So, we have two ways of preventing the Clubhead from pulling into it's own Orbit.

1st. Hold the Clubhead inside the Arc of the Hands
or
2nd. Hold to a Line Deliver Path


The diagrams below illustrate holding the Clubhead inside the Arc of the Hands and then what happens when we allow the Center of the Clubhead Arc to move to the Left Shoulder. When we move the Center of the Clubhead Arc to the Left Shoulder, the Clubhead moves outside the Arc of the Hands.

I know it needs a lot of work. The diagrams are really awful. I need time to think about them.