[mattsdad]

I orginally thought the same way you did, but I recently saw a MOI guide which indicated that weight in the hosel has a modestly lower MOI factor than weight on the rear corner of the club's sole.

I like my clubmaker alot, but I too didn't understand his idea to lower my clubhead's weight to 207 grams. I was so curious, I started this thread. Thought this was the right forum to ask about a hitter's club setups. (Interesting to learn that other hitters like back weighting, which I do as well.)

My shaft's swingspeed range is 89 to 99 mph, and my swing averages around 92 mph. Would you think the extra 7 mph would be sufficient leeway to handle the extra 12 grams of clubhead weight?

First of all, I would be surprised if Wishon would be able to hand pick a head as light as 195 grams. The spec is 202 grams, and typical tolerances are +/- 2 grams. Assuming you wanted a total head weight of 209 grams, I would get Wishon to hand select the heaviest head they have and then reduce the amount required in the weight port and still achieve 209 grams. There may be a theoretical increase in MOI by adding weight to the outside of the head, but it would be insignificant in the scheme of things.

As for the shaft, it would be best to ask your clubmaker for his opinion since he should have a good idea of the shaft load you apply. Assuming the shaft is already cut to length, you can still tip it if necessary and add a shaft extension to get it back to the required length.

FWIW, I am a Swinger and prefer my drivers to be backweighted with about 35 grams.