![]() |
Quote:
http://www.lynnblakegolf.com/index.p...um-Videos.html Kevin |
Thanks Kevin - I will put some time in this afternoon on the putting green. This will be a change from a shoulder dominated stroke to an arm dominated one (mostly right arm). When making longer strokes will the right shoulder be pulled forward a little by the length of the follow thru?
Shoulders would react to the length of the stroke as long as they do not power or initiate the motion - is that correct? Thanks again - Bruce |
Quote:
Well the yips are complex but perhaps one of the TGM defined methods of how to power your stroke might help you with the short ones. TGM has three Zones, 1 pivot, 2 arms, 3 hands. Each one can be used to power to the putter but its best to not combine them for such a low power and precise bit of business. Arnie and the guys who used to put the old slow greens often used a Zone 3, hands only, 10-3-F Peck, Minor Basic Stroke. but you dont see it much anymore unless you're playing with someone from that era. They'd zero out the Pivot and Arms and just use the hands. Most pros today use Zone 1, Pivot Putting, 10-3-H The Paw, Minor Basic Stroke. Using a shoulder rocking action with zero arm participation, so no right arm thrust or straightening, which would be using two Zones and dangerous. Most average golfers today use a bit of both 1 and 2 , typically in a compensating manner, say a push alignment with a right arm thrust that pulls the ball back on line. Very difficult to coordinate and be consistent. Terrible putters can have all three Zones working with a bit of throwaway in the hands added in there. Yikes. Which leaves us with a pure Zone 2, arms only or hitting putting. With the shoulder participation zeroed out the Primary Lever ( the left arm and club) is pulled and pushed through the shot by the Right Arm. There are variations within this procedure so do some research into it. A very effective method but not popular on tour these days. Its key to not add a second Zone or Power accumulator here as well. You need, must get to both arms straight so you have to pre locate the position of the right shoulder so that you have the appropriate amount of right arm to get you to the length of stroke you need at Both Arms Straight. Typically a pushed put is the result of not fully extending the right arm and a pull resulting from unwanted shoulder participation. The fully extended right arm "closes the door" and aligns the clubface properly to prevent the open face push. There is a lot of great information on the Alignment Golf DVD, the entire third CD devoted to putting. |
Thanks O.B. - off to do some practice now. Will have to purchase the Alignment Golf DVD.
Bruce |
You'll like it I bet.
So much information that you just cant get anywhere else. Although with the way Lynns pros are playing it might not be long before it is absorbed by the mainstream. |
Quote:
Your reply to Bruce's question was MASTERFUL and will be of major help to me as well! Thanks, Kevin |
more push basic....
|
2 Attachment(s)
A couple of pics from the work I'm doing. Trying to get my right forearm on plane at setup. I feel like I am standing VERY tall with my hands VERY high. Feel is definitely not real. Getting closer, I would hate to have you see where I was before.
http://www.lynnblakegolf.com/forum/a...d=124354344 6 Position at Follow through. Getting better. Structure at set up is really helping. http://www.lynnblakegolf.com/forum/a...d=124354344 6 And yes, I know I'm too fat! :laughing9 Kevin |
Looking good!
Nice right forearm Hoss.
|
Quote:
Kevin |
| All times are GMT -4. The time now is 06:00 AM. |