![]() |
How does one incorporate low point into the stroke? During address preparation and waggle, should one wave the clubhead in an arc over lowpoint, not the ball? Also, should one try to incorporate lowpoint into one's aiming point, ala thrusting hands and lag pressure to outer edge of the arc at lowpoint, instead of the inside bakcof the ball?
Thanks |
Low point is both under and 'through' the ball, on the inclined plane of force, so there is no way to 'get there' until you make a stroke because you must go 'downplane' and the ball is 'in the way'.
If you were to alter a waggle to hover the clubhead somehow 'outside' the ball location in an attempt to feel more 'out', or to try to stretch to an imaginary low point, you would in fact be off plane. |
Quote:
The ball, of course, is located just to the inside of that point. If your waggle is 3 dimensional I would think one should one wave the clubhead in an arc over ball since it [waggle] is going down out and though to low point. Same is true for the aiming point, since the stroke is D-O-T, the aiming point is designed to reach the low point plane with that nuisance of a ball in the way. :D In a practice swing, after you take a divot, the ball position would be behind the start of the divot, the divot would be low point. |
Quote:
The Wristcock shortens the Swing Radius to facilitate and synchronize the Rhythm and Acceleration of the Pivot and Power Package. The true Angular Speed (RPM) of the Clubhead is identical to that of the Hands due to the mandatory Flat Left Wrist. See 2-N-1 and sketch 2-K#5. So as the Clubhead moves from minimum to maximum radius, its Surface Speed (6-N-0) in miles per hour (MPH) increases geometrically. However, the RATE at which the Clubhead radius increases is an additional velocity factor – that is, its “Overtaking Rate” (6-F). Which is dictated by Hand Speed, Trigger Delay (7-20, 7-23) and Travel and which continues until the In-Line (6-B-0) FULL EXTENSION of the Lever Assembly (6-A) is achieved. So for maximum Power at any Clubhead Speed, the Ball must be struck before Full Extension per 2-N-1. Full Extension (Angular Momentum 2-K) can occur at any time or exist all the time during a Sroke per Pattern, regardless of Impact Point or Low Point (2-N). Impact during Full Extension produces a “soft” Impact and is a very useful simplification. See 2-K and 2-L#2. Centrifugal Force alone Uncocks the Swinger’s Wrists, but Right Arm Thrust during Release is the Hitter’s procedure. Except per 2-M-3 these procedures are not compatible (10-19-0). Per EC, get your wedge hit little shots with the Basic and Acquired Motion. Get to FULLY UNCOCKED!!!! Everytime. Hold your finish at Follow-Through. Is your Left Wrist FLAT AND UNCOCKED FULLY? Are you pointing at the Plane Line? Focus on UNCOCKING DOWN PLANE ON PLANE. Always to FULLY UNCOCKED ALWAYS ON PLANE. Get your Yellow Book out. Look at 4-B-3. Cock Uncock. I yanked a little wire thingie out of my little boy's kite. Stuck it in the hole in the grip of my wedge. I point it at the plane line and Uncock the Left Wrist so the wire thingie moves in the plane of my Left Forearm. Remember per 6-B-2-0 the Second Power Accumulator is the true Velocity Accumulator. Make that club reverse and switch ends FAST. Keep the wrist soft and hammer ON PLANE and DOWN PLANE. Wear out your wedge. |
| All times are GMT -4. The time now is 01:52 AM. |