New to posting, and have read a fair share of info on this site, but unsure still, if it is acceptable to setup with my right forearm inline with the clubs shaft, and swing rather than hit.
Set all alignments and take the grip in Impact Fix conditions including right forearm on plane with the shaft. (Think full-body participation forward press for Impact Fix.)
Then adjust the Address for startup wherever you like, but typically hands at mid-body, which has advantages for swingers. Resist the urge to change the Impact Fix clubface alignment, which is slightly open for swingers to allow for clubface closing rate between impact and separation. You don't swing toward the target. You swing toward low-point, which is under the left shoulder. The ball is up plane from low-point, which makes low-point around an inch outside the ball and forward.
Drag it away from mid-body hands Address tracing the plane line with the right index finger using a right forearm takeaway, up/back/in simultaneously. Allow the hands to naturally swivel 1/4 turn onto plane somewhere in the backswing, which will flatten the left wrist and bend the right to proper impact alignments. Maintain the bend in the right wrist all the rest of the stroke. Hip "bump" parallel to the plane line and trace the plane line with the right forearm, index finger, on the downswing. Quick startdown for swingers. The right shoulder spins the flywheel that is the left arm, right shoulder down plane toward the ball, not out towards the target line, a problem that afflicts 90% of the golfers, or at least a vast number of them. After that is failure to clear the right hip. Try to get a feel for the lagging clubhead and maintain it at all times.
That's only a start. Precision alignment golf requires a lot more detailed explanation, and work.
Look at the Jeff Hull - Yoda Address routine videos, the Collin Neeman series, and get the Lynn Blake - V.J. Trolio Alignment DVDs. Some videos are available on YouTube under LynnBlakeGolf.
Find an instructor or at least arrange for video recording plus analysis tools and learn what to look for.
Beating balls rarely helps. Feel is not real. Spend the most time in the short game area working on alignments until you get crisp, effective contact.
But in the full-swing arena those are not going to be very good without the pivot training to support the intent. Body, arms, hands in that order.
Loren; I dont quite grasp this part of what is being said in your reply to my original post.-
" Quick startdown for swingers. The right shoulder spins the flywheel that is the left arm, right shoulder down plane toward the ball, not out towards the target line, a problem that afflicts 90% of the golfers "
So, if my right shoulder goes down plane toward the ball, is it not it also going toward the target line?
Also, if my right shoulder is driving down toward the ball, is my left shoulder participating actively in the opposite direction?
Loren; I dont quite grasp this part of what is being said in your reply to my original post.-
" Quick startdown for swingers. The right shoulder spins the flywheel that is the left arm, right shoulder down plane toward the ball, not out towards the target line, a problem that afflicts 90% of the golfers "
So, if my right shoulder goes down plane toward the ball, is it not it also going toward the target line?
Also, if my right shoulder is driving down toward the ball, is my left shoulder participating actively in the opposite direction?
Thank you for your help
Wade
Wade . . . Good question . . . essentially you want your shoulders to turn in a circle. You set your "machine" up to what angle you want your shoulders to turn on but they should turn in a circle . . . that is the centered pivot concept. Mr. Kelley believed that all "shoulder" geometry was controlled by the Right Shoulder. Some people like to focus on the left shoulder but not Mr. Kelley. That being said Low Point control is much to do about the left shoulder because that is essentially where the club is going to bottom out (low point) so left shoulder location IS intregal to low point control but the geometry is based on the right shoulder for Machinists. Now that being said WHAT controls the right shoulder?
First you are CORRECT . . . . you want the shoulder to come OUT . . . but its motion is 3 dimensional . . . DOWN OUT AND FORWARD . . . So much like the golf club your shoulder motion can be weighted too much one way or the other. "Over the topper" have to much out and not enough down (club and shoulder) . . . "Under planers" have too much down and not enough out in their shoulder motion. The arms are obviously connect to the shoulders for 93% of the golfing publik . . . so basically the plane of the shoulder controls the plane of the arm swing to a large extent . . .
Second . . . what controls the right shoulder then . . . In order to get enough DOWN in your shoulder motion the PROPER WAY . . you want some Hula Hula in your get down get down . . . IMPROPER DOWN of the right shoulder is going to be the head backing up and down . . . Mr. Kelley calls this a Bob . . . we don't want no Bobbing in golf or no where else for that matter. So Hula Hula motion of the Hips is the answer . . . you want your hips to slide FORWARD inorder for your right shoulder to go DOWN OUT AND FORWARD on plane. This tilts the axis of your shoulder turn so the can turn in a circle on plane with out disrupting the trajectory of the right shoulder with too much OUT (over the top). Mr. Kelley was astute here.
A good way to see how this happens is to find a house that has walls or better yet a house with a door and a door frame . . . stick your fo'head on there and make a backstroke pivot . . . from there . . . slide your hips forward and notice the motion of your right shoulder . . .from there pivot to the finish continuing to push your hips forward and to turn them while your head stays on the wall. Look at what the other pivot components have to do to keep your head on the wall (centered pivot) . . . left knee action, hip action etc. Make some pivots where your head comes up and off the wall . . . notice what happens . . . the hip motion can disrupt the trajectory of your right shoulder which inturn disrupts the trajectory of your amrs . . .which inturn disrupts the trajectory of your club . . . which inturn disrupts the functions (clubhead, clubface, clubshaft control) which inturn disrupts the trajectory of the ball. This is the importance of the centered pivot. You can have the best power package alignments of all time but your pivot motion can override most educated set of hands . . . get the pivot right . . .
Thanks Bucket...Get the pivot right is easier said than done. I can compress the ball with an acquired motion, but the pivot is not good enough for a full swing. The shoulder toward the ball, and the right forearm in line with the shaft make the ball travel very straight, but no compression for me yet on full shots, and divots starting at the ball tell me my pivot is not right. Possibly the shoulders slowing down and /or losing the flat left wrist... I have to go to the range to figure this out.
Linear Mode
